Get matched with top stone and gravel pros in Paris, TX

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.

You should generally drill into the mortar joints when installing shutters on brick. Mortar is softer, which makes drilling easier and puts less strain on your tools. It also lowers the risk of cracking a brick—something that’s a lot harder to fix. Mortar holds fasteners well enough for standard shutters, and if you ever need to patch the holes later, it’s a much simpler job than dealing with damaged brick. Just keep in mind that if your mortar joints are too thin or the hardware calls for brick anchoring, you'll need to check the manufacturer’s recommendations and adjust accordingly.

They offer durability, aesthetic appeal, and resistance to weathering compared to concrete or asphalt.

Yes, technically, you can pressure wash the paint off of brick. However, you run a much greater risk of damaging the brick and causing serious problems. If you go this route, you’ll still need to carefully choose and apply a chemical paint stripper before washing, following all instructions on the product packaging. Set your power washer to a low pressure to avoid damage.