Top-rated deck cleaning pros.

Get matched with top deck cleaning pros in Mathis, TX

Enter your zip and get matched with up to 5 pros

Need a pro for your deck cleaning project in Mathis, TX?

Select your specific project to find the pro for you.

Find Deck cleaning pros in Mathis

...
Showing 1-10 of 51
Deck Cleaning questions, answered by experts

Building a deck without a permit could lead to fines for both the homeowner and the contractor. The exact penalties will depend on your state and municipal building laws. You might also be required to remove the deck and apply for a permit before you can build another. While it might be tempting to skip the permit to save a few bucks, it’ll cost you much more if you’re caught.

The most likely causes of a deck leaning to one side are damaged deck posts, soil erosion, and inadequate deck footings. If you’re not sure about the exact cause, the best option is to call a contractor who can build a deck to inspect the damage and recommend the best way forward.

Building codes for deck railings can vary by location, so it's important to consult your local regulations before construction. Generally, a guardrail is required for any deck that is more than 30 inches above the ground.

For residential properties, the standard minimum height for a deck railing is 36 inches. However, some states and municipalities have stricter requirements; for example, California and Washington mandate railings that are at least 42 inches high. Therefore, a 42-inch railing is not considered too high and may be required in your area or chosen voluntarily for additional safety.

In addition to height requirements, codes also specify other safety features, such as the maximum spacing between balusters to ensure they are close enough to prevent a child from squeezing through.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.

Whether composite decking is better than wood depends on your priorities, especially regarding budget and maintenance. Composite decking offers superior longevity (30 to 50 years) and durability, and it is low-maintenance, requiring no sanding, staining, or sealing. In contrast, wood decks typically last 10 to 30 years and need refinishing every few years. While the upfront cost of composite is higher than wood, the reduced maintenance can lead to long-term savings. If a lower initial cost is the primary factor, wood is the more affordable choice.

The Mathis, TX homeowners’ guide to deck cleaning services

From average costs to expert advice, get all the answers you need to get your job done.