Best doorbell installation pros near Haslet, TX

When installing board and batten siding, make sure there is wall sheathing and a moisture-resistant barrier installed. Behind that sheathing should be plywood or OSB for you to nail the boards and battens into. If there isn’t plywood or OSB, you can install vertical furring strips at 1½- to 2-foot intervals to nail the boards and battens to.

You do not always need to remove old insulation before adding new. If the existing insulation is in good condition—not wet, physically damaged, moldy, or infested with pests—you can add new insulation directly on top of it for a compounding effect. You can also mix different types, such as adding blown-in insulation around existing fiberglass batts.

However, removal is recommended if the old insulation is compromised by water damage or pests. You should also remove it if you plan to install a different type of insulation, like switching from roll or batt insulation to spray foam. If the existing insulation is very old or damaged, you will likely get more benefit from removing it and starting fresh.

Yes, you can use too much bubble wrap. If you overdo it with the wrapping, it can strain the top of your box and break open the taped seal, risking the chance that the contents of the box could fall out or break. Use enough wrapping to fully cover your item without compromising the security of your box.

If you feel your energy bills are too high or your HVAC system is working harder than necessary to maintain the correct temperature in your home, you may have an under-insulated home. If you’re unsure, consider having your system’s efficiency assessed by a local independent energy auditor.