Get matched with top epoxy flooring pros in Graham, TX

Unlike staining concrete, painting concrete often results in chips and peeling over time. You can expect numerous touchups over the years if the concrete is in a high-traffic area. Since concrete paints are opaque, you may also find it more difficult to get the exact color results you want. Lastly, painting concrete can make it much more slippery unless you mix in an additive for traction.

Yes, you can seal old or existing concrete, but proper preparation is crucial. The concrete surface must be clean, dry, and free of any incompatible old sealant. To check if an old sealer is present, drip a few drops of water onto the surface; if the water is absorbed in under five minutes, it's ready to be resealed. If you plan to use the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are using a different type of sealer, the old one must be completely removed. Before applying the new sealer, thoroughly clean the concrete and repair or fill any cracks to ensure a smooth, well-prepared surface.

Resurfacing a garage floor takes about eight hours on average, with another couple hours over three days to do the epoxy. Epoxy goes on in three coats, with each coat taking 24 hours to dry and cure. You’ll need to keep foot and vehicle traffic off of your garage floor for around 4 days in total when replacing your garage floor, so be sure to plan ahead before you start. This is a great time to organize your garage since you’ll need to move everything out to apply the epoxy.

Epoxy coatings for garage floors offer a variety of finish and design options, including:

• Decorative colored flakes: $10 per 250-pound bag

• Metallic epoxy: $5–$12 per square foot

• Rock or stone epoxy: $100 per gallon

• Acrylic and poly-acrylic sealants: $0.85–$1.15 per square foot

• Polyurethane sealant: $0.95–$1.10 per square foot

• Polyurea sealant: $150 per gallon