Get matched with top masons in Elm Mott, TX

No, it’s not recommended to attach shutters to brick without drilling. Brick is dense and built to last, so adhesives and shortcut methods don’t usually cut it. Even heavy-duty glue struggles to hold up over time—especially against wind, moisture, and temperature changes. Most no-drill options are made for materials like vinyl or wood, not solid masonry. Skipping the drill might seem easier, but it puts your shutters—and anything below them—at risk. For a secure, lasting install, drilling is the way to go. It takes more effort up front, but the result is safer and more reliable.

If you want to make your home eco-friendly, enjoy low maintenance, and love the fact that its looks will take people’s breath away (and not because they were trying to blow your house down), then a modern brick home is right for you. You can hire a mason to get the building process started for your brick home.

But if you’re not fond of the color and don’t want to deal with the process of repointing or other repairs, consider going with vinyl or wood. These materials offer a lower cost. While they tend to require more maintenance, they don’t cost nearly the same as exterior brick house repair.

Brick stain doesn’t peel or chip and is much more durable than painting. That’s because the staining is absorbed into the brick instead of lingering on the surface as paint does. The color retains even under extreme weather conditions. Therefore, brick stain will save you a lot of time and cost on maintenance in the long run.

Drilling into brick or mortar requires the use of a masonry drill bit. Masonry drill bits appear similar to standard drill bits except for the leading tip of the bit. The tip has a bulky carbide arrow-shaped end slightly larger than the rest of the bit shaft. Standard or high-speed drill bits designed for making holes in wood or metal don’t have the ruggedness or design shape you need to drill into brick. They may not go through the brick at all, and if they do, they’re more likely to overheat, crack, or dull before you finish drilling.