Get matched with top concrete driveway pros in Daingerfield, TX

When comparing installation costs, asphalt is often less expensive upfront than concrete. Asphalt prices typically range from $7 to $15 per square foot, while concrete can range from $3 to $18 per square foot. However, long-term costs should also be considered. Concrete driveways generally last longer (up to twice as long) and require less maintenance, which can make them more affordable over their lifespan. While asphalt has a lower installation cost and is easier to repair, it requires more frequent maintenance, such as sealing, which can add up over time. Therefore, while concrete is more expensive initially, its durability may offset the cost in the long run.

Whether you need to winterize your pressure washer depends on where it will be stored. If it's kept in a location where temperatures could drop to freezing, any liquid left in the water pump can freeze, expand, and cause severe damage to the machine. To prevent this, you can add antifreeze to the pump. While emptying the machine with compressed air is an alternative, it can be a tedious process and may not remove all the liquid. If you can store the pressure washer in a relatively warm place with no risk of freezing, you won't need to add antifreeze. However, regardless of storage conditions, it is good practice to empty the gas chamber and refresh the oil before storing it for the winter.

You can whiten concrete for unsealed and unfinished concrete with a solution or either muriatic acid or bleach and water—but never both. However, if your concrete does have a stain, finish, or polish, keep in mind that these hard chemicals could damage the topcoat. Your best bet otherwise is to power wash outdoor concrete slabs or clean indoor ones with a gentle cleaner such as laundry or dish detergent.

If there is standing liquid on your concrete, remove it before attempting any of the above cleaning methods. For small amounts of water, use rags, a bucket, and a mop. For larger areas of liquid, lay down cat litter or baking soda to soak up the water first. If you have extremely large pools of water sitting on your concrete, break out the wet vac and get to work.