Get matched with top deck cleaning pros in Greenback, TN

It depends on the type of wood. The average cost to build a deck out of pressure-treated lumber is $15 to $25 per square foot, but more affordable varieties such as bamboo and cedar cost less at around $3 to $10 per square foot. However, when comparing the cost of vinyl decking versus wood decking, it’s important to also consider ongoing maintenance costs. For example, most woods require regular sealing to keep them protected against weather and rot.

While eco-friendly decking, also called composite decking, is a win for the environment because it consists of recycled materials, it has trade-offs. These sustainable options often come with steeper price tags, lack natural wood's warm look, and can become uncomfortably hot under full sun. Some composite materials can also become slick when wet, posing a potential hazard.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.