Top-rated contractors.

Get matched with top contractors in Bruceton, TN

Enter your zip and get matched with up to 5 pros

Need a pro for your contractor service project in Bruceton, TN?

Select your specific project to find the pro for you.

Find Contractors in Bruceton

Expedient Services Group INC
5.0(
9
)
Major Home Repairs (General Contractor)

Serving Bruceton, TN and surrounding areas

In business since 1980

Free estimates

Warranties offered

"Ron Alomar and his crew did an amazing job at my house. He took our ideas and executed them so perfectly. Our house looks amazing. We couldn’t be happier with the outcome. And he is always there to answer any questions or concerns we have had along the way."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+28

Response time1 day
Response rate100%
Recommended by66%of homeowners
Avatar for Homemade Design
Homemade Design
3.7(
322
)
Major Home Repairs (General Contractor)

Serving Bruceton, TN and surrounding areas

In business since 2006

Credit card accepted

"I never contacted the provider or used this service in anyway. I have to
write this review so that the request to write this review stops
popping up.
The rating is bogus as it is required to be able to submit.
"
Pennsylvania Master Bathroom
Boston Small Condo Kitchen
California Client Saves with HMD Designer Discounts
Recommended by54%of homeowners
Avatar for Jill Seidner Interior Design
Jill Seidner Interior Design
3.5(
89
)
Major Home Repairs (General Contractor)

Serving Bruceton, TN and surrounding areas

In business since 2006

Credit card accepted

"Once I sent her all the measurements, it took her a little while to get the options back to me.  Overall, they're good designs.  However, they're very simplistic and give general ideas for space planning.  I was hoping to have a better idea for sizes of furniture for the space and some variations on staging.  
Jill was very responsive when I did have a question.  I'm not sure how helpful it is to have a virtual design done.  If we lived in similar cities, I'd probably use her again for help with additional designs.
"
Recommended by55%of homeowners
Restorable Solutions LLC
5.0(
5
)
Major Home Repairs (General Contractor)

Serving Bruceton, TN and surrounding areas

In business since 1997

Free estimates

Credit card accepted

"Mr. Eggleston and one of his crew members came out and looked at the chimney to inspect for mold. After the inspection was over Mr. Eggleston explained in detail the kind of mold and what to use to remove it. I didn't want to do it myself for health reasons, so, they came later that evening and cleaned the chimney. I still saw areas that weren't cleaned in the upper area of the chimney. I called and was told they would return after lunch; which they did, to clean it. I chose this company because they responded very qiuckly; no waiting around for a call. I felt at ease with this company from Angie's List."
Recommended by100%of homeowners
Showing 1-10 of 29
Unfinished Carpentry questions, answered by experts

Bump-out additions can extend anywhere from 2 to 15 feet from an existing room. The right size will depend on how you plan to use the new space. For a cantilever bump-out, which doesn't require additional foundation support, the limit is typically 24 inches (2 feet). If a footing and foundation are part of the project, a bump-out can be much larger, even encompassing a whole room. It's also important to remember that many residential properties have limits on the total house size relative to the lot size.

Yes, a one-story house can have a load-bearing wall. The load-bearing walls in a single-story home are usually the exterior walls. If the house has a basement with exposed walls, the arrangement of the beams can help indicate what walls are load-bearing.

The easiest way to tell if a wall is load bearing is to check if it’s an exterior wall or if it runs perpendicular to the joists above and below it (or parallel to beams). Exterior walls are almost always load-bearing, and walls that run under beams or parallel to them are also usually load-bearing. There are exceptions to these rules, and walls that don’t fit into these categories can still be load-bearing. If you’re unsure, hire a structural engineer to look at your home to assess whether or not the wall is structural.

A few signs that you need a new door frame include:

  • The door no longer fits properly in its frame and sticks or scrapes.

  • You notice cracks, holes, or rotting.

  • You feel a draft coming from around the door when it’s closed.

  • You find yourself frequently needing to make repairs.

Yes, you can find ceiling joists using simple tools if a stud finder isn't available.

Using a hammer requires patience and a keen ear. Gently tap the ceiling in a grid pattern, listening for sound changes. A hollow sound indicates space between joists, while a solid, dull thud suggests a joist. Mark the location with a pencil and confirm by tapping from different angles.

Alternatively, you can use a nail, but this method will leave small holes. You'll feel increased resistance when the nail hits a joist. Mark the spot and repeat the process every 16 or 24 inches to map the joist locations. This method is considered less reliable than using a stud finder.

The Bruceton, TN homeowners’ guide to contractor services

From average costs to expert advice, get all the answers you need to get your job done.