Top-rated bathtub restoration pros.

Get matched with top bathtub restoration pros in Selby, SD

Enter your zip and get matched with up to 5 pros

Need a pro for your bathtub restoration project in Selby, SD?

Select your specific project to find the pro for you.

Find Bathtub restoration pros in Selby

Avatar for American Tubs....

American Tubs....

2.33(
3
)

American Tubs....

2.33(
3
)
Customers say: Terrific value
13 years of experience

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

Bathtub Restoration questions, answered by experts

You can resurface or reglaze your bathtub, and it’s faster and less expensive than replacing a bathtub. Plus, replacing a bathtub is an extensive and intrusive process that requires wall repairs. Refinishing is an excellent option if the old one is in good working condition.

There are also options to install a bathtub liner over your existing tub. However, if you’re seeking a new bathtub with new features, you’ll likely want to replace your tub.

Bathtubs chip for a number of reasons. The primary cause is simply an accumulation of accidents or direct impact from objects over time. Heavy items will do this, like an iron, but so will lighter objects, like shampoo bottles, especially if you drop them from high enough.

Most homeowners need to wait at least two days, sometimes three, to use their bathtub following the reglazing process. That’s the normal length of time it takes for epoxy resin to cure. There are quick-dry epoxy kits available that cure in 12 hours, though. To ensure that the epoxy dries properly, try to ventilate the bathroom as well as you can.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Yes, you can use a dremel tool to cut plexiglass. Follow the instructions under “How to Cut Plexiglass with a Saw,” and use a dremel tool with a 561 bit instead of a saw.

The Selby, SD homeowners’ guide to bathtub restorations

From average costs to expert advice, get all the answers you need to get your job done.

See all articles