Get matched with top stone and gravel pros in Porcupine, SD

You will repoint over a fraction of the old mortar, but you should scrape away 1/2 to 1 inch of mortar from the joints before repointing. Otherwise, the repointing is only masking the weakened mortar instead of actually replacing it, which could put your chimney at risk of bigger, more expensive damages later on.

Real stone is exactly what it sounds like: It’s real stone sourced from the earth without additives. It is durable and unique, but it’s difficult to work with because of its weight, challenge in sourcing, and high cost. Stone veneer mimics the look of real stone but is actually engineered with a mixture of Portland cement, natural minerals, and a colorant. While it’s more affordable and easier to work with, it’s less durable and may appear manufactured to the trained eye.

Some older brick material is extremely hard, making it tough to create a hole. Rather than using a typical wood drill bit, always use a masonry drill bit when drilling into brick. For extremely hard brick, using a power drill with a hammer function may give you better results. The drill bit will heat up as it goes into the extremely hard brick, so you may need to stop after a few minutes and allow the bit to cool before starting to drill again.

It is possible, albeit a lot slower, to break up a rock using water. You would do this by freezing and thawing the water. You could create some initial holes or cracks in the rock, then pour water into the cracks or holes and allow them to freeze (so it's best to do this in winter or in colder climates). Since water expands when it freezes, this puts pressure on the inside of the rock and causes it to crack. You could continue to pour more water in and let it freeze to continue to break up the rock.