Get matched with top buffing and polishing pros in Porcupine, SD

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

Repair kits make it possible to do the job yourself for small chips or scratches. However, professional services ensure a seamless finish and prevent further damage.

Avoid using abrasive cleansing powders on natural stone, as these products could damage the porous material. Using bleach is also a poor idea because of the porosity of the stone. Avoid using a scrub brush with metal bristles, as they could scratch the stone. If you know who manufactured your stone or who installed the fireplace, you may want to contact that entity for any advice on cleaning it safely.

If you would rather use vinegar to clean the stone fireplace instead of dish soap, this mixture should work fine. Vinegar is slightly acidic, however, so it may etch some kinds of stone without quite a bit of diluting. For a stone fireplace, dilute it to about one cup of vinegar for every gallon of hot water. It’s a smart idea to test the diluted mixture in an inconspicuous area of the fireplace and watch for etching. You can use vinegar to clean quite a few different items around your home, and it’s especially good at removing stains.