Get matched with top bathtub restoration pros in Montrose, SD

Bathtubs chip for a number of reasons. The primary cause is simply an accumulation of accidents or direct impact from objects over time. Heavy items will do this, like an iron, but so will lighter objects, like shampoo bottles, especially if you drop them from high enough.

Yes, you can absolutely remove rust from a bathtub drain, and doing so can improve the appearance of your tub. Combine three parts baking soda with one part vinegar and mix into a paste. Apply the paste over the drain and let it sit for about an hour before rinsing with cold water. Repeat the process if some rust stains remain. If the stains return, consider installing a water softener, as ongoing issues with bathtub drain rust usually indicate hard water.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Refinished bathtubs typically need to be refinished every five years or so. Frequent cleaning and use will break down the finish and make cracks and chips appear more readily. Cracks and chips tend to grow once they begin unless they are repaired immediately. Ideally, you should refinish your bathtub before it gets old enough that refinishing isn’t worth the hassle.