Top-rated bathtub restoration pros.

Get matched with top bathtub restoration pros in Miller, SD

Enter your ZIP and get matched with up to 5 pros

Need a pro for your bathtub restoration project in Miller, SD?

Select your specific project to find the pro for you.

Find Bathtub restoration pros in Miller

AAA Plumbing

1401 Oregon St
4.69(
39
)

AAA Plumbing

1401 Oregon St
4.69(
39
)
Customers say: Quick response
36 years of experience

Additional email - [email protected]

"Guys were on time, friendly and worked quickly. They installed a new kitchen faucet and a soap dispenser. For sure would hire them again."

Steve L on September 2018

Additional email - [email protected]

"Guys were on time, friendly and worked quickly. They installed a new kitchen faucet and a soap dispenser. For sure would hire them again."

Steve L on September 2018

Avatar for American Tubs

American Tubs

17940 Ajax Cir
2.33(
3
)

American Tubs

17940 Ajax Cir
2.33(
3
)
Customers say: Terrific value
13 years of experience

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

American Tubs designs and manufactures a complete line of premium quality Walk-In Bathtubs that are ideal for people with Limited Mobility, Seniors, Disabled and people with pain, arthritis, stress and other debilitating conditions.

Bathtub Restoration questions, answered by experts

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

While they’re heavier than their counterparts, cast-iron tubs are very simple to maintain. They have no seams and are durable, making them the easiest tub to maintain. While fiberglass and acrylic tubs are also relatively simple to maintain, they often have seams, making maintenance a little more difficult.

Resurfacing or refacing extends the life of existing surfaces, saves on replacement costs, and reduces waste, offering a refreshed look with less downtime.

A peeling bathtub is not a good thing. It’s a sign that the finish is coming off, and continued exposure to water and cleaning products can continue to damage the finish and eventually the underlying structure of the tub. What starts as a few chips or flakes can worsen into large chunks peeling off.

For a standard-sized bathtub with minor damage, it takes approximately 3 to 5 hours to refinish. It might take a bit longer if your bathtub refinishing contractor needs to fill in significant cracks or gouges. This is the same if you have a specialty tub, like an oversized bathtub—you can expect your pro to take a bit on the longer side.

The Miller, SD homeowners’ guide to bathtub restorations

From average costs to expert advice, get all the answers you need to get your job done.

See all articles

What do you need done? We’ll find top pros.
  • 🌱 "Mow a small front yard"
  • 🛠 "Fix a leaking pipe under the sink"
  • 🏠 "Repair shingles on an asphalt roof"