Get matched with top stone and gravel pros in Ethan, SD

Depending on the amount of soot present, you can vacuum some of it using a brush attachment on your vacuum cleaner. Then, remove the leftovers with a mild cleaner, such as dish soap or vinegar mixed with water. Before applying a cleaning solution, saturate the bricks with clean water to prevent the cleaner from penetrating beyond the surface and causing structural damage to the bricks.

You may not need a hammer drill if you’re planning on drilling one or two very small diameter holes in brick. For holes with a diameter of 3/16-inch or less, a regular drill with a masonry bit can do the job. However, the bit will heat up quickly, and the process will take significantly longer than with a hammer drill. Prepare to cool your drill bit down in a bucket of water more often.

Yes, technically, you can pressure wash the paint off of brick. However, you run a much greater risk of damaging the brick and causing serious problems. If you go this route, you’ll still need to carefully choose and apply a chemical paint stripper before washing, following all instructions on the product packaging. Set your power washer to a low pressure to avoid damage.

Cutting stone comes with a number of safety hazards. First and foremost, if you’re not comfortable with the equipment required to cut stone, including blades and grinders, you could easily injure yourself. The heavy machinery also poses a risk to your ears if you don’t wear proper ear protection; similarly, you need to wear eye protection to keep debris from irritating your eyes.

However, the biggest risk from cutting stone comes from the stone dust. When breathed in, stone dust can be a huge hazard to your lungs. Always wear a face mask when cutting stone to prevent inhaling stone dust, and thoroughly clean the work area when you are finished.

To avoid injury, we recommend hiring a stone-cutting professional, rather than attempting this job yourself.