Get matched with top deck staining pros in Beresford, SD

Wood stain is not flammable after it dries. The solvent in wood stain is what causes the liquid form to be highly flammable, but the stain drying process involves the solvents dissolving, which leaves behind a non-flammable product on your wood project. Wood stain is, however, flammable before you apply it, so you should always store partially full cans and used wood stain rags away from sources of heat and open flames.

Provided conditions are ideal, staining an entire deck should take as little as a couple of hours and up to a couple of days to apply and cure. Additional procedures, like sealing a deck or using additional treatments, may extend the project by a few additional days.

Yes, it is important to wash your deck before painting to ensure the paint applies well and adheres properly. While you don't have to use a pressure washer, it is one of the most efficient cleaning methods. Pressure washing can quickly remove dirt, wood fibers, and flaked paint, getting deeper into the wood than manual scrubbing. You can also clean the deck with a stiff broom and a cleaning solution. Regardless of the method, a clean surface is essential for good paint adhesion. Make sure the deck is completely dry before applying any paint.

The opposite is actually true: Wood stains tend to appear lighter when they’re fully dry. However, stains may darken as they weather and oxidize with age. Stains might also darken on surfaces left in direct sunlight, as UV rays can break down pigment particles and cause them to darken over time.