Get matched with top gas log pros in Estill, SC

Plumbers start by walking around the property to see if they notice any signs or sounds of a gas leak. They can also use tools like electronic gas detectors and infrared cameras to find the source of leaks. There are also detectors that use laser, thermal, and multi-wavelength imaging. All these devices allow a plumber to scan your home and pinpoint the exact location of a leak.

Installing a gas line is no simple task. From start to finish, you’re looking at anywhere from six to 12 weeks to acquire the correct permits, dig a trench, and connect your appliances. Naturally, the longer the gas line, the longer it will take to complete. If your plumber needs to hire additional contractors to dig trenches and navigate around or remove obstacles, this could put you at the longer end of the timeframe. 

Once the land is prepped and licenses acquired, installing the actual line may only take a few days to a few weeks, weather permitting.

If your home uses more than one gas appliance, you'll continue to use gas, even outside of the heating season. Your water heater, gas stove and oven, and gas dryer will all use some gas, although typically much less than a furnace. Additionally, those appliances may also have a pilot light that is lit continually, using a small amount even when no one is at home.

The cost to repair a gas leak is $120 to $250 on average, but it could be as costly as $5,000, depending on the leak location and severity. 

For example, if you have drywall covering the source of the leak, you'll need to hire a contractor to replace the removed drywall. In addition, if the leak is underground, you'll need a contractor to excavate the ground to reach the gas line.