Top-rated deck repair pros.

Get matched with top deck repair pros in Brunson, SC

Enter your zip and get matched with up to 5 pros

Need a pro for your deck repair project in Brunson, SC?

Select your specific project to find the pro for you.

Find Deck repair pros in Brunson

Avatar for WN Construction
WN Construction
4.8(
32
)
Deck or Porch - Repair

Serving Brunson, SC and surrounding areas

In business since 2018

Free estimates

Emergency services offered

"Job started when committed - professional and very personable. I'm thrilled with the job they did on my built-in bookcases, dog door, trim repair, installation of a shelf and a stoop in front of my storage shed. II've already given them a list for future fixes. Highly recommend."
7
6
5
4
8

+95

Response time2 days
Recommended by100%of homeowners
Avatar for His And Hers Handyman Maintenance
His And Hers Handyman Maintenance
5.0(
8
)
Deck or Porch - Repair - For Business

Serving Brunson, SC and surrounding areas

In business since 2022

Emergency services offered

Warranties offered

"I had a great experience with his and hers handy man maintenance last week. I needed my bathroom and kitchen repaired. the technician was very professional and knowledgeable. They arrived on time. Diagnosed the issue quickly and fixed it within 1 hour. The cost was reasonable and office staffs was friendly. I highly recommend."
Mailbox
Mailbox
Mailbox
Mailbox
Flooring

+66

Showing 1-10 of 34
Deck Repair questions, answered by experts

Staining and sealing the underside of a deck creates a moisture barrier but traps water in the boards, quickly leading to rot. No matter how well you seal the above deck, water still gets through via nails and screw heads on the surface. Allow this water to flow naturally under the deck, where it is routed through the drainage system.

The best and fastest way to remove paint from a deck often involves combining a chemical stripper with a pressure washer. Gel-based paint strippers are highly recommended because their thick consistency makes them less messy and easier to apply than liquid strippers. After applying the stripper to loosen the paint, you can use a pressure washer to efficiently wash away the residue. When using a pressure washer for this task, it's important to use a low pressure (under 1000 PSI) to avoid forcing too much moisture into the wood, which could lead to mildew or rot.

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.

PVC decking tends to be cooler than composite because the material is less dense and absorbs less heat. However, it depends on the deck’s color. A dark-colored PVC deck may run hotter than a light-colored composite deck. If you’re concerned about your deck getting too hot, it’s best to stick to a light color such as beige or gray.

To prepare a deck for a hot tub, start by thinking about safe and easy access in and out of the tub. Homeowners should plan for steps or consider built-in seating, a level surface around the perimeter, and a clear, slip-resistant path from the house. A hot tub requires sufficient space around it for comfortable entry and exit, ensuring no awkward squeezing or stepping over high edges. Good lighting and handrails can also make a big difference, especially for nighttime use.

The Brunson, SC homeowners’ guide to deck repair services

From average costs to expert advice, get all the answers you need to get your job done.