Get matched with top sonic cleaning pros in Yeadon, PA

You should avoid using a pressure washer on any surface or item that could be damaged by the high-pressure spray, as some materials are too delicate to withstand the force.

Key items and surfaces to avoid include:

• Electrical Components: Never pressure wash electrical systems, as water can cause short-circuits and create a safety hazard. This includes utility meters, breaker boxes, electrical outlets, generators, and HVAC or air conditioner units.

• Delicate and Fragile Materials: Fragile items can crack, shatter, or be stripped by the pressure. Avoid pressure washing windows, glass, light fixtures, shingled roofs (especially asphalt), and stucco.

• Painted, Stained, or Sealed Surfaces: Unless your goal is to strip the finish, do not pressure wash painted surfaces, stained wood (like decks), or anything with a protective seal that could be stripped away. Be especially cautious with older surfaces that may contain lead paint.

• Soft Woods and Certain Decking: Delicate surfaces like softwood, composite decking, and antique or wooden patio furniture can be etched or damaged. If you must wash wood, use a lower-powered pressure washer with a wide-angle nozzle to prevent damage.

• Living Things: Never use a pressure washer on people, pets, or plants. The force can cause serious injury and will destroy landscaping.

It may require stronger cleansers or chemicals, higher-pressure spray, or scrubbing to completely remove algae from a metal roof. Start with a mild cleanser; if that doesn’t work and you're comfortable doing so, use a stronger mix of ⅓ cup of laundry detergent, 1 quart of bleach, and 3 quarts of water to gently scrub the algae with a soft-bristled brush. If algae is present across large portions of your roof, doesn’t come off with gentle scrubbing and cleansers, or is in hard-to-reach areas, this may be a job better left to a pro.

Chemical herbicides will kill moss permanently. The same goes with bleach water. However, moss can start growing again once a new layer of dirt and debris is caught in your sand in paver joints. Therefore, the problem is not about killing moss permanently, but ensuring effective prevention of moss regrowth.

Moss grows in dark areas of roofs, including in corners and gutters. If left alone, it can grow under roofing and cause permanent damage. Here’s how to remove moss from metal roofs: 

• Soak the moss to soften it

• Scrub it away with a soft-bristled brush, or pick it off with your hands (be sure to wear gloves)

• Use a moss remover that’s compatible with metal roofing, following the manufacturer’s directions

• Remove dead moss and rinse the roof thoroughly

• Prevent future moss growth by trimming branches, cleaning gutters, and attaching zinc strips to moss-prone areas