Best countertop and backsplash pros near Seneca, PA

Solid surface countertops are fairly resilient. You can use soapy water or ammonia-based cleaners. You can also occasionally use diluted bleach (around 5 tablespoons per gallon of water) for sanitization. Avoid window cleaners because they leave a waxy film that can dull the countertop’s surface. Solid surface material is nonporous, so there’s no need for sealing.

The least expensive way to build a kitchen countertop is to choose an affordable material. For example, laminate countertops cost about $1,250, while Corian® countertops cost $4,000 on average. Common wood and laminate tend to be the most affordable and DIY-friendly, which will save you the cost of labor. Otherwise, look for lower-end solid surface countertops or ceramic and stone tile. These cost less than natural stone slabs.

Recycled glass countertops are slightly cheaper than quartz countertops, though it depends on several factors. Recycled glass countertops cost between $65 and $140 per square foot, and quartz countertops cost $50 to $200 per square foot, though most projects come in at $70 to $100 per square foot. The final cost will come down to the quality of the material, local labor prices, and any customizations you require.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.