Get matched with top gutter cleaning pros in Gardners, PA

If you want to avoid burying your downspouts, several alternatives can help direct water away from your home's foundation. One option is to connect a rain barrel to your downspout. During a storm, the barrel collects water that you can later use for irrigating your lawn or garden. Another common solution is to install an above-ground downspout extension. This can be done in a couple of ways:

• Splash Guards: Placing a splash guard, available at most hardware stores, under your downspout can act as a simple funnel to direct water away from the house.

• Downspout Extensions: You can add an extension to the end of the downspout's elbow to carry water further into your yard. Some extensions are flexible, allowing you to maneuver them around landscaping.

These above-ground solutions are particularly useful if your home has a slab foundation that you cannot dig up. However, they have limitations. An extension may not move water as far from your home as an underground system. More importantly, if your yard slopes back toward your house, these methods will be ineffective, and burying your downspouts remains the best option to prevent potential flooding and water damage.

Using less toilet paper is the easiest way to prevent future clogs. Also, avoid flushing sanitary products, thick paper towels, or hair down the toilet. If you’ve been using a brick in the tank to reduce the water used to flush the toilet, take it out immediately. Bricks will eventually fall apart and clog your toilet drain. Keeping your toilet lid closed also helps avoid future clogs.

Gutters overflow in heavy rain for several reasons. The main reasons why your gutters could be overflowing in heavy rain include:

• Not enough downspouts to effectively remove water from your gutters

• Too small of a gutter width—the average gutter size is four to six inches

• Clogged gutters

• Incorrect slope

If you believe your gutters were installed incorrectly, it’s a good idea to know who to call for gutter leaks. Speak with a local gutter specialist to get to the bottom of your gutter system to stop water from flooding your property or yard ASAP.

Yes, you can use a pressure washer to effectively clean debris, dirt, and grime from your gutters, but it must be done with caution to avoid damage. Always use a low-pressure setting, with a recommended range between 1,200 and 1,800 PSI. Excessive pressure can bend or dent aluminum gutters, damage seams, peel paint, or even knock shingles off your roof, potentially leading to leaks and moisture issues. For a safer alternative, consider soft washing or cleaning them by hand. When using a pressure washer, it is safer to use gutter elbow extensions from the ground rather than climbing a ladder, as the force can cause instability. Due to the risks, you may want to hire a licensed and insured contractor for the job.