Top-rated welders.

Get matched with top welders in Felton, PA

Enter your zip and get matched with up to 5 pros

Need a pro for your welding project in Felton, PA?

Select your specific project to find the pro for you.

Find Welders in Felton

Avatar for Simple Fence, LLC
Simple Fence, LLC
5.0(
34
)
Wrought Iron Fence - Repair or Weld

Serving Felton, PA and surrounding areas

Approved

In business since 2020

Free estimates

Credit card accepted

"The work was excellent. From the beginning of my communications with the company until the job was completed was always professional, timely, and answered all questions I had. I will definitely have Simple Fencing come back and do some additional work that I need done. Please do not hesitate to call Andrew and have work done by this company."
3 neighbors recently requested a quote
Recommended by52%of homeowners
...
Showing 1-10 of 65
Welding questions, answered by experts

Yes, you can use a saw to cut metal pipes. The best saw to use is a reciprocating saw, but even a fine-tooth hacksaw can get the job done. No matter which saw you use to cut metal pipes, wear protective gear, like work gloves, safety goggles, and ear plugs. Apply a firm, steady pressure to the tool, and always ensure the pipes are secured so they don't move while you make the cuts.

Cutting round ductwork requires precision and the right tools. A duct cutter, specifically designed for circular ducts, is ideal. First, mark the cutting line on the duct using a measuring tape and pencil. Then, position the duct cutter's blade on the marked line. Apply steady pressure, rotating the cutter around the duct. The sharp blade creates a clean, precise cut. Alternatively, a reciprocating saw with a metal-cutting blade can be used for larger round ducts. Ensure the duct is securely held in place while making the cut to prevent slips and maintain accuracy.

It will likely take an experienced pro less than an hour to install a ground rod, which is another reason why letting them handle the job is such a good idea. Safety concerns aside, it would likely take you much longer to install a ground rod if you decided to take this one as a DIY job.

Professional metal fabricators typically charge around $70 per hour, but the total cost of your project will depend on several factors. The largest cost drivers are the size, complexity, and design of the project, as well as the price and type of metal used. A good way to estimate the total cost is to multiply the cost of raw materials by four; typically, one-quarter of the total goes toward materials and three-quarters toward labor. Your geographic location can also influence costs, as labor and material prices vary by region.

This all depends on the tools you have on hand and whether you’re trying to cut a straight line or shapes. 

The best tool to use for straight lines is either a circular saw or table saw. When cutting shapes, a jigsaw will be the easiest and most precise tool to use. 

The Felton, PA homeowners’ guide to welding services

From average costs to expert advice, get all the answers you need to get your job done.