Get matched with top woodworkers in Dexter, OR

Tipping contractors, builders, or general contractors is not customary or expected. Unlike many service professions where tipping is built into the payment structure, construction professionals typically charge a full rate for their services. However, you may choose to tip a worker for exceptional service, such as if they go above and beyond, stay late to meet a deadline, or work on a holiday weekend. Before offering a tip, it's a good idea to ask about the company's policy, as some prohibit their employees from accepting gratuities. If you want to show your appreciation for a job well done without giving a cash tip, consider writing a positive online review or offering to serve as a reference for potential new customers.

You don’t need a cutting board. In fact, cutting is the original purpose of butcher block countertops. That said, wood is porous and can harbor germs. You’ll need to clean your countertop thoroughly after use. Knives can also scratch the surface. This adds to the patina of the wood, but not everyone likes the look—in which case, you may want to use a cutting board.

If you’re just replacing a few broken or damaged joists, you can expect to pay anywhere from $100 to $300 per joist. However, a complete installation for a home or room will take into account the cost of labor, which ranges from $25 to $40 per hour. Floor joist installation for an entire room, for example, can cost between $5,000 and $10,000, depending on the room's size and the materials used.

Yes, you can find ceiling joists using simple tools if a stud finder isn't available.

Using a hammer requires patience and a keen ear. Gently tap the ceiling in a grid pattern, listening for sound changes. A hollow sound indicates space between joists, while a solid, dull thud suggests a joist. Mark the location with a pencil and confirm by tapping from different angles.

Alternatively, you can use a nail, but this method will leave small holes. You'll feel increased resistance when the nail hits a joist. Mark the spot and repeat the process every 16 or 24 inches to map the joist locations. This method is considered less reliable than using a stud finder.