Top-rated electricians.

Get matched with top electricians in Weleetka, OK

Enter your zip and get matched with up to 5 pros

Need a pro for your electrical service project in Weleetka, OK?

Select your specific project to find the pro for you.

TRUSTED BY WELEETKA, OK HOMEOWNERS

  • Average homeowner rating star icon4.9
    Average homeowner rating
  • Verified reviews icon11
    Verified electrical services reviews

Find Electricians in Weleetka

Avatar for Corrigan, LLC
Corrigan, LLC
4.8(
25
)
Lightning Protection - Install or Repair

Serving Weleetka, OK and surrounding areas

Approved

In business since 1954

Free estimates

Emergency services offered

"John Corrigan and his sons are outstanding! They did outstanding work installing our lighting rods at a reasonable price. They were prompt, very professional and honest. I would call them again and recommend them to anyone."
Shingle roof air terminal
Residential 1
Residential Spanish tile
Horse stable
Residential 2

+23

Response time2 days
14 neighbors recently requested a quote
Recommended by100%of homeowners
...
Showing 1-10 of 63
Electrical questions, answered by experts

There are a few reasons your lights may be on, but the rest of your electrical outlets and appliances are not working. The first is that while one circuit blew out, the lights may be on another circuit than your other electrical fixtures. Alternatively, your powerless appliances may be plugged into a GFCI outlet that was tripped and needs to be reset. If these issues aren’t responsible for the problem, you may have dead outlets or a wiring issue. Either way, you should contact an electrician to identify and fix the issue.

The common, marked as COM or C, is one of the terminals found in your light switch. It houses the live wire that supplies the input voltage. The other terminals, marked as L1 or L2, are the outputs to the light fixtures. Depending on if you have a one-way or two-way switch, you’ll either have just an L1 terminal or both an L1 and L2 terminal.

Yes, it’s possible to use a three-way switch as a two-way switch. You can use a three-way switch as a two-way switch by bypassing one of the traveler wires and using only one of the available traveler switch terminals.

You can make a pigtail with either thermoplastic high-heat-resistant nylon-coated (THHN) wire or non-metallic (NM) cable, often referred to as “Romex.” Each pigtail requires a neutral wire, a ground wire, and a live wire. The gauge of your pigtail wires must match the gauge of those on the device. 

A ground wire is not required for GFCI to work. A ground is a third wire in an outlet in addition to the live and neutral wires. It serves as an escape conduit for electricity in case of a short circuit. If a ground wire is present, installers should connect it to the appropriate terminal. Otherwise, a GFCI will work fine without it.

The Weleetka, OK homeowners’ guide to electrical services

From average costs to expert advice, get all the answers you need to get your job done.