Get matched with top epoxy flooring pros in Walters, OK

To keep your stamped concrete surfaces shiny, experts recommend resealing them every two or three years. Regularly cleaning your stamped concrete (at least twice per year, as part of routine maintenance) is another way to increase its sheen. Also, if you notice any spills or leaks, you should clean your stamped concrete as soon as possible to preserve its shine and prevent long-term damage.

Apply two coats of paint to a garage floor after priming for optimal results. The first coat serves as a base layer, providing adhesion and coverage. Allow the first coat to dry thoroughly before applying the second coat, typically after 12 to 24 hours. The second coat ensures even coverage and durability and enhances the floor's appearance. Additionally, applying two coats helps to create a more substantial barrier against stains, chemicals, and wear and tear, resulting in a longer-lasting finish. 

Spills like water, oil, or grease can wear down the epoxy's strength, lowering its lifespan. While this damage doesn’t happen immediately, it can accumulate over time, so cleaning up any garage spills as soon as they happen is essential. Avoid cleaning with or using dish soap on your epoxy floors since they will leave an unattractive residue. Instead, you can use half of a cup of ammonia diluted with a gallon of water for cleaning purposes.

Yes, you can seal old concrete, but proper preparation is essential. Before sealing, ensure the concrete is clean, dry, and free of any old sealant. To check if resealing is necessary, place a few drops of water on the surface; if they are absorbed in less than five minutes, it's time to reseal. If you are using the same type of sealer that was previously applied, you may not need to remove the old layer. However, if you are applying a different type of sealer, the existing one must be removed. Additionally, repair or fill any cracks to create a smooth base before you begin sealing.