Get matched with top roofers in Ripley, NY

Hail is unlikely to damage a tar and gravel roof because the hailstones will hit the protective gravel rather than your delicate roof membrane. A tar and gravel roof is the most resilient flat roof option, which means it’s the best one for areas that see hail, fallen tree debris, and blown debris from intense winds.

The proper specifications for furring strips can vary, so you should always consult the roofing manufacturer's guidelines or your roofer. However, general recommendations are as follows:

• Thickness: Furring strips are typically 1 to 1-1/2 inches thick, meaning standard 1-by or 2-by lumber works well. In areas with extreme winds, a thinner strip may be preferred to limit how much air can get under the roof and cause uplift. A thicker strip can add slightly more insulation but will also increase installation costs.

• Spacing: The recommended spacing for furring strips is between 12 and 24 inches apart on center. Proper spacing is crucial for ensuring good airflow, adequate drainage, noise reduction, and better energy efficiency. The ideal spacing can depend on the roof's pitch and the specific type of metal roofing being installed.

A roof replacement can take anywhere from one to 14 days. For most homes, a full replacement that includes tearing off old materials takes about one to two days, though the average project can last up to 12 days. The exact timeline depends on several factors, including the roof's size and complexity, the type of roofing material, the crew size, and weather conditions. Certain materials take longer to install; for example, metal roofs can take seven to 14 days because the material is more difficult to work with than asphalt shingles, wood, or tile. A re-roofing project, where new shingles are installed over old ones, can take half the time or less. It's also important to factor in the time needed to obtain necessary permits. A professional roofing contractor will typically complete the job faster than a DIY approach.

Furring strips (also called wood stripping) are not always necessary for a metal roof installation, but they are highly recommended and may be required by local building codes or the roofing manufacturer's specifications. There are several key reasons to use them:

• Energy Efficiency: Furring strips, made of wood or metal, create an air gap between the metal panels and the roof deck. This acts as a thermal break, reducing heat transfer into your home and improving overall energy efficiency.

• Moisture and Condensation Control: The air gap allows for better airflow, which helps prevent moisture buildup and condensation under the metal panels.

• Structural Support: They provide a solid, even frame to which you can attach the metal roofing panels.

It is especially important to use furring strips when installing a metal roof over existing shingles. Without them, the roof surface can be uneven, and you will experience greater solar heat gain.