Top-rated deck maintenance specialists.

Get matched with top deck maintenance specialists in College Point, NY

Enter your zip and get matched with up to 5 pros

Need a pro for your deck maintenance project in College Point, NY?

Select your specific project to find the pro for you.

Find Deck maintenance specialists in College Point

Avatar for A&M Construction, Corp.
A&M Construction, Corp.
4.3(
16
)
Deck, Fence, Patio or Porch - Clean and Seal

Serving College Point, NY and surrounding areas

Approved

In business since 2012

Free estimates

Emergency services offered

"They were responsive and did the work quickly. The quality was good. They did put a couple of scuffs on the floor moving an appliance, but then cleaned them. They had some complications with the work, but persevered and figured things out on their own. Overall the experience was good."
new bathroom
New York New York
New York New York
New York New York
New York New York

+57

Response time4 hrs
Recommended by85%of homeowners
...
Showing 1-10 of 210
Deck Maintenance questions, answered by experts

In many areas, a floating deck that isn’t connected to your home and stays under 200 square feet and below 30 inches in height may not need a permit. These freestanding structures are often considered low-risk, which can simplify the building process. However, building codes vary greatly based on location. Before investing in any home improvement project, check with your local permitting office for deck-building guidelines.

Whether you need a permit depends on the deck design and local regulations. Most areas mandate a building permit if the deck is over a specific height or if it's attached to a pre-existing structure. Shorter, freestanding decks may not require a permit, but you should check with local zoning ordinances and your homeowners association for specifics.

Rot loves moisture, so deck rot typically impacts the parts of a board that stay wet. This includes the underside of boards, in addition to support posts and joists. However, any part of a board can rot, given the right conditions. 

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

It’s best to prime composite decking before painting. This promotes better paint adhesion, helps create a smooth finish, and can mean the paint job will last longer. Always follow the manufacturer’s instructions for application, allow ample primer drying time before painting (typically 24 to 48 hours), and thoroughly clean the deck boards to promote the best adhesion.

The College Point, NY homeowners’ guide to deck maintenance services

From average costs to expert advice, get all the answers you need to get your job done.