Top-rated well and pump technicians.

Best well and pump technicians near Ely, NV

Enter your zip and get matched with up to 5 pros

Need a pro for your well and pump service project in Ely, NV?

Select your specific project to find the pro for you.

Top-Rated Well and pump technicians in Ely - Updated Nov 2026

Avatar for Choice Home Warranty
Choice Home Warranty
4.0(
5,678
)
Well Pump - Install or ReplaceWell Pump - Repair or Service

Serving Ely, NV and surrounding areas

In business since 2008

Emergency services offered

Credit card accepted

"Went well to this point of replacing parts. Then the United needed to have a system leak test and then needed freon put in pump. This was refused by Choice warranty. We were left with a partial repair and a heat pump not able to do it's job."
Recommended by81%of homeowners
Wells and Pumps FAQs, answered by experts

The Centers for Disease Control and Prevention (CDC) recommends testing your well at least once a year to check for bacteria and contaminants. If you live in an area prone to flooding, runoff, or any other environmental concerns, it can be a good idea to check two to three times per year.

A shallow-well pump can pull water up to 25 feet deep. A deep-well pump can pull water up to 90 feet deep. A deep-well submersible pump can pull water up to 300 feet deep. Make sure to consult a pro to find out how deep your well is and get the right pump for your needs.

Regular checks of pressure tanks, testing water quality, and cleaning intake screens.

Yes, you can shock a well yourself, but it can be dangerous if you don’t know what you’re doing. We recommend calling a pro, but if you decide to do it yourself, make sure to follow proper safety precautions. This means wearing the correct safety gear, such as rubber gloves, goggles, and boots. You should also mix the chlorine solution in an open area with plenty of ventilation. Also, make sure not to drink or use the water for a few days afterward, until you’ve flushed the system and retested the water.

How do you set your well’s pressure tank? All you need to do is first drain the tank of water and find the pressure switch. Remove the switch cover and adjust the switch with a wrench—clockwise to increase water pressure, and counter-clockwise to reduce it. Each complete turn of the nut on the switch should equal 2.5 psi. Once this is done, replace the switch cover. All that’s left is to adjust the pressure of the tank itself using an air compressor and a tire gauge to support the new setting.

The Ely, NV homeowners’ guide to well and pump services

From average costs to expert advice, get all the answers you need to get your job done.