Top-rated asphalt driveway pros.

Get matched with top asphalt driveway pros in Tatum, NM

Enter your zip and get matched with up to 5 pros

Need a pro for your asphalt driveway service project in Tatum, NM?

Select your specific project to find the pro for you.

Find Asphalt driveway pros in Tatum

Avatar for Sangre De Cristo Paving & Excavating
Sangre De Cristo Paving & Excavating
4.2(
34
)
Asphalt Paving - InstallAsphalt Paving - Install- For BusinessAsphalt Paving - Repair or Patch+3 more

Serving Tatum, NM and surrounding areas

In business since 1986

Free estimates

Emergency services offered

"Mike was the lowest bidder. That often concerns me, but in the actual event, he worked around difficult weather conditions to get the job done before winter set in. His crew was professional. The repairs were done correctly and cleanup was excellent. At one point, we discussed a difficult driveway that had not been asphalted because this neighbor is recovering from a devastating financial setback brought on by health issues. This led to a significant erosion issue after every major rain. A trench had developed through the width of the driveway. Mike said he would add in a fix for her drive at no extra cost to the HOA that had contracted with him for the other repairs. I expected a few feet of asphalt to cover the culvert that was crushing and eroding. He actually created a driveway entrance about 30 ft. wide and extending about 12 ft. up the drive. I was stunned. See the included photo. He and his crew went far beyond our expectations both in the work we had contracted for and also in the work he offered to do for out neighbor. I would highly recommend Mike and Martin's Asphalt to anyone. I included photos of the drive way fix and one of four roadway patches."
Additional Photos
Additional Photos
Additional Photos
Additional Photos
Additional Photos

+17

Recommended by92%of homeowners
Avatar for DFM Concrete, Inc.
DFM Concrete, Inc.
5.0(
5
)
Concrete Driveways & Floors - Install- For Business

Serving Tatum, NM and surrounding areas

In business since 2001

Free estimates

Credit card accepted

Welcome to DFM Concrete! We take pride in the quality of work and customer satisfaction that we give each customer! With over 35 years experience, we are known to pay exquisite attention to detail while making customer satisfaction our top priority. Call us today to learn more about how we can help you!

O'Reileys Auto
Waste Water Plant
Residential In Ramah
Response time2 days
Response rate93%
Showing 1-10 of 20
Asphalt Driveways questions, answered by experts

While some areas may allow for a slope of up to 20%, this is often the maximum slope for driveways, with a few exceptions of up to 25%. Other regions may have a maximum of 12%, 15%, or 18%, so check with your local building department to ensure you’re laying a driveway that is up to code for your location.

An asphalt driveway should be at least 3 inches thick over a compacted gravel base. Areas with poor drainage should have a thicker stone base. To install a new asphalt driveway over an existing driveway, the new asphalt should be at least 2 inches thick and the existing driveway should be in relatively good condition.

Overall, a paver driveway is considered the easiest to maintain because homeowners are able to do driveway repair one piece at a time without impacting the rest of the driveway. Unlike paved options, paver driveways contain individual stones that aren't physically connected. By comparison, you may need to reseal or redo a full asphalt driveway if just one portion sustains a significant crack.

Asphalt is not a type of concrete. While both are a common type of pavement, asphalt is composed of aggregates (like sand and gravel) and bitumen; concrete is a mixture of cement, aggregates, and water. Here are some of the key differences between asphalt and concrete driveways.

In most cases, you don’t need a permit to repave your driveway, although some exceptions exist. If you’re widening your driveway and plan on widening the apron as well, you’ll usually need a permit from the Department of Transportation in your area. This permit costs between $50 and $300 in most cases. Most municipalities will also require a certified and insured contractor do the work relating to the apron and curb cut. You can contact your building department or ask your paving company if you need a permit. Your driveway professional will usually pull the permit for you.

The Tatum, NM homeowners’ guide to asphalt driveway services

From average costs to expert advice, get all the answers you need to get your job done.