Get matched with top vinyl siding cleaning pros in Chaparral, NM

If you’re trying to cover up damaged vinyl siding with some other material, properly repairing the damage is likely just as easy. Avoid covering up damaged siding under most circumstances. Water and mold can easily get trapped behind it and cause more harm than the damage already there. 

If you need a fast, temporary repair until you have time to fix the damage properly, use a generous amount of caulk or spray foam insulation to fill the gap, knowing that you’ll need to remove the material later. 

The recommended PSI (pounds per square inch) for cleaning vinyl siding can vary, so it's best to consult the manufacturer's guidelines. Generally, vinyl siding can handle high pressure, from 2,500 to 3,500 PSI. For comparison, more delicate materials like wood and aluminum siding should not face more than 1,500 PSI. To safely disperse the pressure on vinyl, use a tip with a wider spray span, such as a green (25-degree) or yellow (15-degree) nozzle. For routine cleaning of light dirt, a garden hose with a spray nozzle may be sufficient. Always exercise caution to avoid using excessive pressure that could damage the siding.

The average cost to repair hail damage to a home is around $1,100, but you could pay anywhere from $250 to $3,000 or more, depending on the extent of the necessary repairs. If a hail damage repair company determines your roof is too old or too damaged to be worth repairing, then you might pay an average of $9,200 to replace your roof. Excessive hail damage may be covered by your homeowner’s insurance policy or a home warranty, so check those policies before paying out of pocket for roof repair or replacement.

Because vinyl is a type of plastic, it can start to melt and then warp when it has been exposed to too much heat. While you can’t control the amount of sun your home gets every year, you can take some precautions to help your vinyl siding. Choose lighter colors for your siding, such as whites, off-whites, and beiges; these colors will reflect light rather than absorb it. You should also avoid oil-based coatings, which tend to crack more easily when applied to vinyl—this allows more heat to get to the siding.