Get matched with top garbage removal pros in Dublin, NH

If your garbage disposal powers up and you can hear it hum, but the arms inside aren’t moving, the problem might be a stubborn clog, a build-up of grease, or a jam of the impeller plate. To troubleshoot these, ensure your unit is off and disconnected from its power source before checking inside the drain or attempting to manually rotate the impeller arms or plate from the underside of the unit. A hex wrench can help.

When a dishwasher discharges its wastewater, it uses a pump to quickly move a lot of water. If anything in the drain line or the garbage disposal impedes the high volume of water, it will back up into the sink through the drain or the garbage disposal. Following regular dishwasher maintenance tips like clearing clogs, keeping them cleared, and occasionally running the disposal will eliminate the problem.

While unplugging your garbage disposal and plugging it back in may help, most units have an actual reset button, a bright red switch found on the underside of your unit. If your garbage disposal needs resetting, you may notice this button sticking out about a quarter of an inch from the surface of the unit, with which it’s usually flush. Simply depress this reset button to reset the unit, and then test to ensure it’s working about 10 minutes later.

Once you have your garbage disposal disconnected, you can remove the mounting bracket by unscrewing the bolts that are holding the bracket. You can back them out just enough to pop off the snap ring, which prevents the bottom portion of the bracket from disconnecting from the top when you unscrew the bolts. Use a regular screwdriver to pop off the snap ring, and the rest of the components should fall off by themselves.