Q: What are the cons of reglazing a tub?

• <div><p>The reglazed tub won&rsquo;t last as long as a brand-new bathtub. Professional reglazing jobs can only last up to 15 years.</p><p>According to most pros, you can only reglaze a tub once or twice. So, if you&rsquo;ve already reglazed your tub once, it might not be a realistic solution.</p><p>Some chemicals used in reglazing a bathtub can be dangerous to your health. If you&rsquo;re DIYing the project, ensure the room is ventilated, and always wear a mask. If you hire a contractor, make sure you get the clearance to use the bathroom again. </p></div>

Question 1

What causes holes in a bathtub?

Accepted Answer

•

While tubs are fairly sturdy, you may notice cracks or holes. This kind of damage can happen from someone accidentally dropping something heavy into the tub. You might also see damage if you drop something heavy into the tub over and over again (like your extra large bottle of body wash). While you might only notice a small dent at first, this can later turn into a crack or a hole.

Also, certain cleaners that are harmful to your tub can cause damage. And if you have a fiberglass tub, you might see cracks if it was not installed properly with the right support.

Question 2

What are the cons of reglazing a tub?

Accepted Answer

•

The reglazed tub won’t last as long as a brand-new bathtub. Professional reglazing jobs can only last up to 15 years.

According to most pros, you can only reglaze a tub once or twice. So, if you’ve already reglazed your tub once, it might not be a realistic solution.

Some chemicals used in reglazing a bathtub can be dangerous to your health. If you’re DIYing the project, ensure the room is ventilated, and always wear a mask. If you hire a contractor, make sure you get the clearance to use the bathroom again.

Question 3

Can you use Epsom salt in a reglazed or refinished bathtub?

Accepted Answer

•

Yes, you can use Epsom salt in a refinished bathtub. The salt will not harm the new glaze finish chemically, although it may rough up the surface finish a bit. Consult a professional bathtub refinisher prior to using Epsom salt on your bathtub to ensure it won’t damage its finish.

Question 4

How long should I wait to use my bathtub after reglazing it?

Accepted Answer

•

Most homeowners need to wait at least two days, sometimes three, to use their bathtub following the reglazing process. That’s the normal length of time it takes for epoxy resin to cure. There are quick-dry epoxy kits available that cure in 12 hours, though. To ensure that the epoxy dries properly, try to ventilate the bathroom as well as you can.

Question 5

Are there other ways to refinish a bathtub?

Accepted Answer

•

Two alternatives to reglazing are installing a bathtub inlay or a bathtub liner. An inlay is a low-priced mat that adheres to the bottom of a bathtub or shower. It’s useful for sealing minor leaks and concealing damage on the bottom of a tub. On the other hand, a bathtub liner is essentially a protective casing that goes over the entire tub. They are usually custom-fit and cost more than reglazing yet don’t last as long.