Get matched with top bathtub restoration pros in Fullerton, NE

There are a few signs, both obvious and not so obvious, that it's time to refinish your bathtub. While some of these signs aren't an urgent problem, others could lead to significant damage if left untreated. Signs you should look out for include:

• Rust stains, which signal the tub's enamel or surface sealer is deteriorating 

• Small chips, which can grow into larger chunks and can lead to rusting

• Discoloration, which doesn't lead to a more significant problem but can be unsightly 

• Dirty surfaces, which means that the tub glaze is breaking down and allowing dirt to seep below the coating

Resurfacing or refacing extends the life of existing surfaces, saves on replacement costs, and reduces waste, offering a refreshed look with less downtime.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

Two alternatives to reglazing are installing a bathtub inlay or a bathtub liner. An inlay is a low-priced mat that adheres to the bottom of a bathtub or shower. It’s useful for sealing minor leaks and concealing damage on the bottom of a tub. On the other hand, a bathtub liner is essentially a protective casing that goes over the entire tub. They are usually custom-fit and cost more than reglazing yet don’t last as long.