Question 1

How long should I wait to use my bathtub after reglazing it?

Accepted Answer

•

Most homeowners need to wait at least two days, sometimes three, to use their bathtub following the reglazing process. That’s the normal length of time it takes for epoxy resin to cure. There are quick-dry epoxy kits available that cure in 12 hours, though. To ensure that the epoxy dries properly, try to ventilate the bathroom as well as you can.

Question 2

Should I refinish my bathtub or replace it?

Accepted Answer

•

The cost of installing a new bathtub is considerably more expensive than refinishing an existing one, so if you’re looking to upgrade your tub on a budget, you might be better off refinishing it for now. Additionally, if your tub has only minor damage, refinishing it will make it look new again without the extra demolition and time.

Question 3

Is it less expensive to resurface or replace a bathtub?

Accepted Answer

•

Resurfacing a bathtub is less expensive than replacing one. Resurfacing a tub costs about $330 to $630, depending on the material, while replacing a tub costs an average of $4,150. But remember that resurfacing is a temporary solution for a worn-out tub, and you may need to refinish a tub every few years to keep it looking new.

Question 4

How long do fiberglass bathtubs last?

Accepted Answer

•

Fiberglass tubs last between 10 and 15 years or more if they’re well-maintained. Proper care will help them last as long as possible. However, fiberglass bathtubs are prone to cracking, fading, and scratches over time. Bathtub installation by a plumber is one of the best ways to ensure your tub has the right support to last its full lifespan.

Question 5

Are there alternatives to caulking my bathtub?

Accepted Answer

•

You can use other ways to seal the space where your tub and the bathroom tile meet. Using sealant tape, epoxy sealer, and spray foam can be just as effective as caulking your bathtub. When using alternatives to caulk, the one that is best for you depends on your preferences.

Sealant tape takes less time and effort to use, which is why some homeowners prefer it. Meanwhile, epoxy sealer creates a smooth and glossy finish that can complement your bathroom. Lastly, spray foam is waterproof and can act as insulation for your tub.