Get matched with top bathtub restoration pros in Wahpeton, ND

There are a few ways to check whether your tub is fiberglass or acrylic. If your tub is a color other than white, then your tub is likely acrylic (as fiberglass tubs are usually white). Check to see if there is discoloration on the bottom of the tub, because if it’s yellowed, then you can be fairly sure it’s fiberglass.

Also, fiberglass tubs have thinner edges and are cool to the touch. Acrylic, on the other hand, is either room temperature or warm to the touch.

Before you begin caulking a shower, you’ll need to use a utility knife or solvent to remove the old caulk and inspect the area for mold. If needed, take appropriate steps to get rid of the mold, then wipe everything down with dish soap and warm water before letting it dry completely. Finally, surround the caulking area with two strips of blue painter’s tape—one above the joint where you’re caulking and another below it.

For a standard-sized bathtub with minor damage, it takes approximately 3 to 5 hours to refinish. It might take a bit longer if your bathtub refinishing contractor needs to fill in significant cracks or gouges. This is the same if you have a specialty tub, like an oversized bathtub—you can expect your pro to take a bit on the longer side.

While tubs are fairly sturdy, you may notice cracks or holes. This kind of damage can happen from someone accidentally dropping something heavy into the tub. You might also see damage if you drop something heavy into the tub over and over again (like your extra large bottle of body wash). While you might only notice a small dent at first, this can later turn into a crack or a hole.

Also, certain cleaners that are harmful to your tub can cause damage. And if you have a fiberglass tub, you might see cracks if it was not installed properly with the right support.