Get matched with top pressure washers in Minto, ND

A pressure washer is okay to use on epoxy floors and won’t remove the concrete coating if you use a lower pressure setting and the correct nozzle, such as a green, white, or black nozzle, for gentle cleaning. Be careful using a power washer, which adds heat to the pressurized water, because this may be too powerful and could damage the epoxy.

Yes, you can pressure wash epoxy garage floors. Most epoxy floors can be cleaned with a mop, but you may choose to pressure wash your floor if it is stained, has ground-in dirt, or is covered with mold or mildew. Before pressure washing, soak stains and dirty areas with a gentle cleanser for best results. Then use a pressure washer tip angled at 45 degrees and raise the spray nozzle to at least 18 inches off the floor to protect the flooring surface. You can also use a surface cleaner power washer or rotary scrubber to prevent overspray. 

Always use a soft washer to clean your gutters—you can also clean them by hand. It’s tedious work, but it keeps your gutters intact. Pressure washers have PSIs of 1,500 or even more, which is strong enough to cause damage to your gutters or to knock shingles off your roof. When your gutters are damaged, your home is more susceptible to moisture, which can lead to mold and mildew problems.

A pressure washer’s size or power is measured in pounds per square inch (PSI). The amount of pressure you need will depend on your project and the material you’re washing, but consumer pressure washers range from 500 to 2,400 PSI. Porous materials like brick and stucco should not be blasted with anything stronger than 1,000 PSI, while you can use a PSI of up to 2,400 to clean a vinyl fence.