Get matched with top deck maintenance specialists in Elgin, ND

Cutting the boards directly is one of the fastest ways to remove deck boards with hidden fasteners. Mark two parallel lines that are one-third of the total measurement on both ends and cut out the centerpiece. Then, remove the end of the board that doesn’t have a fastener. Finally, pry open the fastened side and pull it up to pop out the screw or access the fastener. This also allows you to salvage portions of boards for other projects.

Building codes typically require handrails if your porch is 30” or more off the ground. However, it's important to check your local regulations and building codes to make sure, as this can differ depending on your location. When in doubt, check with a local porch handrail pro, who will know the local codes and be able to get permits if any are required.

Any wood deck provides some ventilation to the area below, as is the nature of that type of deck design. However, areas that experience excessive humidity and associated moisture benefit greatly from a dedicated ventilation system in the form of strip vents. This addition helps the various wood boards contract and expand evenly throughout the years and reduces the chances of twisting, warping, and buckling.

No, you don’t need a permit to repair and replace a few boards on an existing deck. However, if you’re making structural changes to the deck or tearing down the old one and building a new one, you will likely need a permit. Check with your local municipality for the regulations and rules in your area, or ask a local contractor who builds decks for advice.