Get matched with top countertop and backsplash pros in Edenton, NC

A minimum overhang of 10 to 12 inches is generally recommended for countertop or island seating to provide enough legroom. For increased comfort, an overhang of 15 to 18 inches is ideal, allowing for more space and a relaxed experience. However, a 10-inch overhang can be sufficient in certain situations, such as for bar-height countertops, when using small stools, or in smaller kitchens where space is limited. Taller countertops may also require less overhang than shorter ones. Ultimately, you should consider your specific needs for legroom and measure to ensure the overhang fits comfortably within your kitchen's layout.

Granite is one of the most popular options for countertops, and most homeowners believe that granite countertops are worth the money. Granite is more affordable than marble and quartz, and provides outstanding durability and longevity. Granite countertops are also desirable because they are entirely unique; unlike some other countertop materials, your granite slab won’t be identical to any others. Granite is porous, which means it has the potential to stain if you don’t clean up spills quickly, but the general durability and relatively low cost make it well worth the investment.

The least expensive way to build a kitchen countertop is to choose an affordable material. For example, laminate countertops cost about $1,250, while Corian® countertops cost $4,000 on average. Common wood and laminate tend to be the most affordable and DIY-friendly, which will save you the cost of labor. Otherwise, look for lower-end solid surface countertops or ceramic and stone tile. These cost less than natural stone slabs.

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.