Get matched with top floor polishers in Red Lodge, MT

Yes, you can mop hardwood floors with a damp flat or string mop as long as it is not soaking wet. Always avoid leaving standing water or fully soaking your hardwood floors, even if they are properly finished. A slightly wet mop, with or without cleaning solutions, will not damage the wood.

Professionals use various tools and cleaning solutions based on the type of floor they’re cleaning. They often use industrial steam cleaners to pull debris out of the carpet. For localized stains, they may use a commercial cleaner or a mixture of water, vinegar, and dish soap. For tile, they’ll typically use dish soap and hot water, plus a mixture of baking soda and hot water for the grout. For cleaning wood floors, they might use a low-heat steamer, a mop with an oil wood floor cleaner, or a mixture of hot water, vinegar, and lemon juice.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

Dust mops are the best option for tackling dirt and dust on marble floors. Vacuums aren’t a good idea as the brushes and beater rolls can scratch and damage your marble floors. If you must use a vacuum, make sure your vacuum has a setting for hard floors, and take care not to apply too much pressure when rolling the vacuum across your marble floor.