Get matched with top floor polishers in Glasgow, MT

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

Services typically take 2-4 hours, depending on the area size and floor material.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

Yes, vinegar and water can strip wax. For a DIY wax stripper, mix about a quarter cup of vinegar with one gallon of warm water. You can also mix one cup of cream of tartar, one cup of white vinegar, and one gallon of water. Before using it on a large area of the floor, you should test it in an inconspicuous place to make sure it works like you want it to.