Best pressure washers near Emigrant, MT

The average cost to professionally clean or pressure wash a deck is around $150, with prices typically ranging from $100 to $600. Several factors influence the final price, including the deck's size, material, condition, and how long it has been since its last cleaning. For a smaller deck of about 300 square feet, you might pay around $100. For a larger deck of 1,000 square feet or more, the cost could be closer to $300 to $400. Decks that are very dirty or haven't been cleaned in years may require more time and special detergents, which will increase the price. The deck's material also plays a role. Wood decks often cost more to clean because they require a gentle power washing technique to avoid damage. Composite decks are typically less expensive to clean, and cleaning a metal deck may cost around $100.

On average, pressure washing a house can take anywhere from 30 minutes to three hours. The time frame to pressure wash or power wash your home, fence, or other property depends on the size of the project and the complexity and accessibility of the areas that need cleaning. Part of the time required to complete the job includes setup and removal of equipment needed. A two-story house with a steep roof may require working from scaffolding or a ladder, likely adding to the time required to finish the project. 

Yes, it is safe to use a pressure washer on your house, but the water pressure is very powerful. If you’re not careful, it can put a hole in your wall or cause injuries to yourself or others. But there are several pressure washing tips you can follow to pressure wash safely, including wearing safety gear at all times.

You should wait until your pavers have completely dried and cured before pressure washing them. Wait at least three to five days, though some sealants may need up to an entire week. Rushing that timeline can mess with the finish, weaken the seal, or leave streaks that are tough to fix. Once the sealant has fully set, stick to a gentle approach. Keep the pressure under 1,500 PSI and hold the nozzle at least two feet from the surface. Anything stronger or closer can blast the joint sand loose or wear down the sealant you just applied.