Top-rated countertop and backsplash pros.

Best countertop and backsplash pros near Utica, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your countertop and backsplash service project in Utica, MS?

Select your specific project to find the pro for you.

Top-Rated Countertop and backsplash pros in Utica - Updated Nov 2026

Avatar for DBS Marble & Granite
DBS Marble & Granite
4.8(
9
)
Stone Slab Countertops - Install (Granite, Marble, Quartz, etc)

Serving Utica, MS and surrounding areas

In business since 2010

Free estimates

Credit card accepted

"DBS was hired for a kitchen and bathroom counter top project. There were a few issues that I had, but they addressed these minor problems in a timely manner. They had no problem returning to the site, and standing behind their work. The whole job turned out great."
KITCHEN
Kitchen
Kitchen
Kitchen
Guest bath

+79

Response time2 days
Recommended by88%of homeowners
Avatar for Jordan Resurfacing
Jordan Resurfacing
4.9(
16
)
Laminate Countertops - InstallLaminate Countertops - RepairSolid Surface Countertops - Install (Concrete, Stainless Steel, etc)+3 more

Serving Utica, MS and surrounding areas

In business since 2019

Free estimates

"I found Mr Jordan on Angie’s List. I have never used Angie’s list before but I will definitely use it again if needed. Jordan Resurfacing was very professional and the price was very affordable. He was careful to not leave a mess and did his job in a timely manner. I was extremely pleased with his work. He even gave us a two year warranty."
Bathtub Refinishing & Liners Project
Bathtub Refinishing & Liners Project
Bathtub Refinishing & Liners Project
Bathtub Refinishing & Liners Project
Bathtub Refinishing & Liners Project

+85

Recommended by100%of homeowners
Showing 1-10 of 23
Countertops and Backsplashes FAQs, answered by experts

You can cut food on tough, scratch-resistant granite countertops. However, these hard surfaces can quickly dull your knife blades, and continual cutting in the same spot can eventually lead to marks forming and compromising the protective sealant. As with any countertop material, it’s always best to use a chopping board.

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.

No, you shouldn’t put hot pans on solid surface countertops because they’re only heat-resistant up to 212 degrees Fahrenheit. Play it safe and use trivits to prevent damage.

Yes, you can remove a countertop without breaking it. It is possible to save your countertop to use in your new kitchen, donate it, or sell it! You’ll just need to work carefully as you follow the removal steps above. If you’re not sure you can get the job done without causing a little damage, call in a pro for peace of mind.

If you want your butcher countertops to last the typical 20 years, you should seal them monthly. Most homeowners use either oil or polyurethane, which helps repel water from the porous material. Keep in mind that if your countertops are in a kitchen, you’ll want to use a food-grade sealant. Tung oil, mineral oil, and beeswax are all popular options.

The Utica, MS homeowners’ guide to countertop and backsplash services

From average costs to expert advice, get all the answers you need to get your job done.