Best roofers near Quitman, MS

Building code allows 24-inch on-center spacing for roof trusses. However, you can install them on 12- or 16-inch centers to handle large loads or other exceptional circumstances. In cases such as covering a wide span or supporting alternative roofing materials, where a structural engineer needs to evaluate or create a design for your trusses, the plans will indicate the spacing. 

Before hiring a roofing contractor, it's wise to ask several key questions. Inquire if they are licensed for roof replacement and repair and if they hold any special certifications. Ask if they will be completing all the work themselves or subcontracting parts of it. It's also important to understand the project timeline, whether they will remove the old roof or place new shingles on top, and how they will handle cleanup after the project is complete. Finally, ask about warranties for both work and materials, what recourse you have if issues like leaks arise, and if they can provide customer references.

Roofers don’t typically replace vent pipes themselves, but they do handle the flashing and seals around vent pipes when working on a roof. During a roof replacement or repair, roofers inspect the vent pipe flashing for damage, replace deteriorated seals, and ensure the pipe is properly integrated into the roofing system to prevent leaks. If the vent pipe itself is cracked or damaged, a plumber is usually required to replace it, while the roofer ensures the roofing components around the pipe remain watertight.

The ridge is the horizontal line where two sloping roof sections meet at the top, forming the highest point of the roof. A hip, on the other hand, is the external angle formed where two roof sections meet and slope downward toward the walls, typically at a lower angle than the ridge. The ridge runs horizontally along the peak and the hip runs diagonally from the peak to the roof's edges.