Get matched with top countertop and backsplash pros in Perkinston, MS

The best tool for cutting countertops depends on the type of countertop material. For some softer materials, like laminate (Formica) and butcher block, you can use a hand saw, but most experts recommend power saws like circular saws, since these make the job go faster and easier and give more even results. However, power saws and circular saws are dangerous if used incorrectly, and they can be so powerful that they damage or chip laminate, stone, and other types of countertops. For this reason, you should take safety precautions and use best practices to prevent damage.

Yes, Corian® and other solid surface countertops can be cut with standard woodworking tools like a circular saw or a jigsaw, but using the correct blade is crucial for the best results.

The recommended blade is a tungsten carbide-tipped blade, often called a solid-surface planer or triple chip grind blade. This type of blade is hard enough to cut through the material effectively. For a jigsaw, a fine-tooth down-cutting blade should be used.

It is important to note that a diamond blade is not necessary. Diamond blades are designed for harder materials like natural stone, concrete, or brick, and Corian is not a natural stone.

Using blades designed for wood is not recommended as they can cause microfractures that weaken the countertop's edges. While a tungsten carbide blade provides a much cleaner cut, the resulting edge will still be rough and must be sanded and smoothed to prevent microfractures from developing over time.

Yes, you can remove a countertop without breaking it. It is possible to save your countertop to use in your new kitchen, donate it, or sell it! You’ll just need to work carefully as you follow the removal steps above. If you’re not sure you can get the job done without causing a little damage, call in a pro for peace of mind.

Yes, Corian® and other solid surface materials can be cut with standard woodworking tools, such as a circular saw or a jigsaw. However, it is crucial to use the correct type of blade to avoid damaging the material.

For a circular saw, a tungsten carbide-tipped blade is required; a triple chip grind blade is highly recommended. For a jigsaw, you should use a fine-tooth down-cutting blade. Do not use blades designed for cutting wood, as they can cause microfractures that weaken the edges of the countertop. A diamond blade is also unnecessary, as those are designed for harder materials like natural stone, which Corian is not.

After cutting, the edge will be rough. It is essential to sand and smooth the cut edge to prevent microfractures, which can eventually compromise the integrity of the countertop.