Get matched with top toilet pros in Newhebron, MS

Many parts of your plumbing system can fail, but clogged drains are one of the biggest plumbing problems you’ll likely encounter. From your kitchen sink, bathroom sink, or bathtub, there are plenty of opportunities for gunk, hair, food scraps, and more to get stuck in drains. When this happens, water will slowly drain, leading to standing water, bad odors, drain flies, and other issues.

Many homeowners can handle a minor clog themselves, but if you have a clog in your main line, you’re best off hiring a local plumber to get the drain back to its normal flow rate.

Yes, and no. Your shower, toilet, and sink all connect to the same main drain, but the secondary drains going from each fixture to the main drain are usually separate. This isn’t always the case—especially in older homes—but since toilets contain black water and showers, tubs, and sinks have grey water, toilets are more regulated and come at a greater risk of contamination. It’s best to keep these drains separate using individual waste collection for this reason.

Yes, a toilet, sink, and shower can share the same vent. This is a common installation method that can simplify plumbing and save space. However, there are important considerations. The vent and associated plumbing must be large enough to handle the demands of all fixtures without compromising the vent's effectiveness. Additionally, the toilet should always be located downstream of all other fixtures. Because requirements can vary and space might be limited, it is essential to check your local building and plumbing codes and consult with a qualified plumber to ensure the installation is done correctly.

The cost to install a new toilet typically runs from $225 to $530. This doesn’t include the price of the toilet itself, which can cost $90 to $1,500 depending on the model and features you choose. You can save money if you choose to install a toilet yourself. However, you might want to hire a pro for this project.

"Due to the many complexities of replacing a toilet flange, it is typically a job best left to the pros," says Jeff Botelho, Angi Expert Review Board member and plumber. "Many times it isn't as simple and straightforward as 'pop off the old one and pop on a new one' because the flange is either glued on (PVC/ABS), soldered on (brass/copper), or caulked in place with a lead & oakum joint (cast iron) and none of these things can be easily reversed without years of training and repetitive practice."