Get matched with top floor cleaners and waxers in New Augusta, MS

To properly maintain and care for hardwood floors without damaging the finish, establish a regular cleaning routine. Sweep with a broom or microfiber dust mop daily, or vacuum weekly, to remove dirt and debris that can scratch the surface; be sure to clean in tight corners and under furniture. For a deeper clean, use a damp mop with a cleaner specifically designed for hardwood floors, but avoid using harsh chemicals or excessive water, as this can damage the wood. You can further protect your floors by placing mats at entryways to catch dirt and moisture and putting felt pads under furniture legs to prevent scratches. For long-term care, refinish the floors as needed to keep them looking their best.

You can buff out small scratches or indentations from your hardwood floor, but refinishing is your best bet if you have larger areas that need work. Floors in relatively good shape but have lost their luster can be restored with thorough buffing. If your finish has worn off in areas or if you have sun or water damage, you should go with refinishing instead.

Dust mops are the best option for tackling dirt and dust on marble floors. Vacuums aren’t a good idea as the brushes and beater rolls can scratch and damage your marble floors. If you must use a vacuum, make sure your vacuum has a setting for hard floors, and take care not to apply too much pressure when rolling the vacuum across your marble floor.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.