Get matched with top fence painters in Cleveland, MS

You should wait three to six months after you buy it to paint pressure-treated wood. It needs time to dry from the chemicals applied to it. The paint will not adhere to the treated wood as well if it’s still wet from chemicals. To test the wooden boards, drip water onto them. If the wood absorbs the water, it’s ready for painting. If the water beads up, it’s not dry enough to paint yet. You can build your deck or fence while the treated wood is still wet, but you’ll need to paint it later.

Maintain your wattle fence by inspecting it at least twice per year for loose weaving and degrading branches. Replace any seriously degraded sections, ensure water drains properly around the posts, and trim any sprouting branches if you used green wood. If you notice the weave loosening, you can often tighten it by gently pushing down on the top branches. You can also apply a natural wood preservative every two to three years to extend the fence's lifespan.

Whether to brush or roll stain on wood depends on the project and your preference. Brushing is ideal for smaller, intricate areas and offers more control over the application, ensuring thorough coverage and penetration into the wood's grain. 

Conversely, rolling is efficient for more extensive, flat surfaces and can save time. However, it is not always the best fit for textured or uneven wood. Some projects may benefit from combining both methods, using a brush for detail work and a roller for broader areas. Ultimately, the choice between brushing and rolling depends on the specific requirements of your staining project.

If possible, it is beneficial to paint both sides of your fence to protect the fence more completely from the elements. Painting both sides of your fence will create a more consistent appearance as well. However, the time and cost involved in painting both sides of the fence may cause people to paint only the side they see.