Get matched with top deck cleaning pros in Charleston, MS

Yes, it is possible to build a small, basic deck for $5,000, particularly if you use less expensive materials and a simple design. To stay within this budget, consider a size under 10x12 feet and use affordable materials like pressure-treated wood or cedar. While the general cost for deck building ranges from $4,350 to $12,560, with an average around $8,200, some projects can be completed for as little as $4,350. You can also save on labor costs by doing the work yourself, but be aware that mistakes could end up costing more than hiring a professional. A contractor may have a higher upfront cost, but they can ensure a safe, stable deck that will last.

It is possible to pressure wash your deck, but it’s usually best to leave the work to a professional for two main reasons. First, power washers are expensive, and you can avoid high upfront costs by hiring a deck washing pro instead. Second, you must be careful to use the correct setting to avoid damaging your deck material. You can only clean soft woods like pine with a wide spray and a low pressure; otherwise, the water will leave unpleasant marks on your deck. Hard woods, composite material, and metal can stand up to increasingly higher water pressures.

Most building codes require that railing spindles (also known as balusters) on decks or stairs be spaced no more than four inches apart. This safety standard is often called the '4-inch sphere rule,' which means a sphere with a 4-inch diameter should not be able to pass through the opening between balusters. This rule is in place to prevent small children and pets from slipping through the railing. For the same reason, the space between the bottom rail and the deck or floor surface should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is essential to check your local building codes to ensure compliance before starting your project.

The best way to sand a deck is by cleaning it, sanding the boards and stairs with 60- or 80-grit sandpaper, and sanding the railings and posts with 80-grit sandpaper. You should sand in the direction of the wood grain to avoid damaging the timber. When sanding your deck, use medium pressure and aim for an even sand. Pressing too hard with a sander can damage decks, as most are softwoods.