Get matched with top countertop and backsplash pros in Belden, MS

Recycled glass countertops can last between 10 and 20 years with regular care and maintenance. The exact lifespan depends on the binding agent used; acrylic is a highly durable choice, while concrete may shorten the countertop's life. Because the material is non-porous, it is heat-resistant, stain-resistant, and easy to clean, allowing it to withstand the rigors of a modern kitchen without showing significant wear and tear for over a decade.

If the damage is minor, you can repair countertops without replacing them. You can also resurface a laminate countertop rather than replace it when it gets old and dingy. Countertop resurfacing is a relatively easy project, though it can be time-consuming, so you may prefer to hire a pro to do this for you.

Porcelain is a relatively affordable, mid-range countertop material. It typically costs between $50 to $70 per square foot.

Compared to quartz, porcelain is slightly more affordable, as quartz generally ranges from $50 to $200 per square foot. However, lower-quality, builder's grade quartz can be similar in price to porcelain.

Compared to granite, the price can be similar, depending on the quality of the stone. While granite slabs can range from $50 to $200 per square foot, you can find lower-end granite in the same price range as porcelain. High-end granites will cost significantly more.

Porcelain is generally more expensive than laminate, acrylic, and ceramic, but less expensive than high-end slate, concrete, and marble. A key benefit is that porcelain does not require sealing, which reduces long-term maintenance costs.

The angle at which you cut countertops depends on the material, your intended outcome, and the location of the cut. For example, rather than cutting a straight 90-degree angle for internal corners, cut edges at a 45-degree angle to give a clean, professional look. For outside edges, most homeowners want squared-off sides, so 90-degree angles can make the most sense there. Because you want to get angles exactly right to minimize seams and eliminate the need for patching, be sure to measure several times before cutting and use the right equipment to get sharp, accurate angles.