Get matched with top deck cleaning pros in Artesia, MS

Unless you’re using a 2-in-1 formula or painting over an existing coat of paint, it pays to apply a coat of primer ahead of your new paint. Decks see a lot of footfall and exposure to extreme and sudden temperature changes and moisture levels. The primer promotes better paint adhesion, moisture repellency, and a smoother finish, which means you’ll often need fewer coats of paint. 

It is definitely worth sanding a deck to ensure the wood absorbs new stain. Sanding a deck removes the outer layers of aging wood, allowing the stain to penetrate. It also gives a fresh look to the entire surface as part of the deck refinishing process. Without sanding, your stain or sealant is less likely to absorb into the wood. While sanding a deck is a time-intensive project, the rewards are noticeable and long-lasting.

It is recommended to clean your deck once or twice a year to prevent the accumulation of dirt, debris, mold, and mildew. The ideal times for cleaning are in the spring and fall. A spring cleaning removes grime that has built up over the winter, preparing your deck for summer use. A fall cleaning washes away messes from summer activities, preventing them from setting into the wood over the winter. The exact frequency can depend on factors such as how often the deck is used, its exposure to pollen, and whether salt was used on it during the winter. Regular cleaning helps protect the wood and its finish from damage.

Most building codes require that spindles or balusters on deck and stair railings be spaced no more than four inches apart. This safety standard, often called the '4-inch sphere rule,' is designed to prevent small children or pets from slipping through the railing. A good way to visualize this is that a 4-inch sphere should not be able to pass between two spindles. For the same safety reason, the space between the bottom rail and the deck floor should also be no more than four inches. As a general guideline, professionals often install three balusters per foot of railing. However, since specific requirements can vary by location, it is crucial to check your local building codes to ensure compliance before starting your project.