Top-rated floor polishers.

Get matched with top floor polishers in Arnold Line, MS

Enter your zip and get matched with up to 5 pros

Need a pro for your floor polishing project in Arnold Line, MS?

Select your specific project to find the pro for you.

Find Floor polishers in Arnold Line

Avatar for BW Cleaning Services
BW Cleaning Services
4.3(
97
)
Clean & Polish Flooring - For Business

Serving Arnold Line, MS and surrounding areas

In business since 2017

Free estimates

Emergency services offered

"These ladies know how to clean. They did a deep cleaning on my house from ceiling to floors. Including base boards, windows, window seals and cabinets. I will definitely use them again."
Response time3 hrs
Response rate97%
Recommended by83%of homeowners
Showing 1-10 of 21
Floor Polishers questions, answered by experts

Professionals use various tools and cleaning solutions based on the type of floor they’re cleaning. They often use industrial steam cleaners to pull debris out of the carpet. For localized stains, they may use a commercial cleaner or a mixture of water, vinegar, and dish soap. For tile, they’ll typically use dish soap and hot water, plus a mixture of baking soda and hot water for the grout. For cleaning wood floors, they might use a low-heat steamer, a mop with an oil wood floor cleaner, or a mixture of hot water, vinegar, and lemon juice.

Yes, but with caution. A floor grinder is intended to level and polish concrete, so it is a very powerful tool. To remove paint, the floor grinder should be set to 35 square feet per minute or less to minimize the pressure without the use of pocket weights. You might need to go over the surface two times to get any paint that has sunk into the concrete’s pores.

The answer to this question depends on how large the room is and how much experience you have stripping and waxing floors. It will take at least 24 hours to strip the floors, then you must allow time for drying, waxing, waiting for them to cure, and, finally, buffing them. Since you likely will not be working for the full 24 hours, it is safe to say that this is a two- or three-day job.

The best way to clean vinyl floors is to vacuum or sweep away debris and then mop the floors using a mixture of warm water and dish soap or vinegar. You can also use store-bought cleaners if they’re marked safe for vinyl surfaces.

While every professional home cleaner will have their own preference, most will use a commercial floor cleaner specifically manufactured for laminate floors. They will also use a vacuum or microfiber cloth to remove loose grit before breaking out the mop. Some cleaners will also make a final pass with a dry and clean cloth to dry your laminate floors for a smooth shine.

The Arnold Line, MS homeowners’ guide to floor polishing services

From average costs to expert advice, get all the answers you need to get your job done.